OLED Module technology and development with echoes, OLED drive also plays an increasingly important role. Not only from the low duty cycle increases to support high duty cycle, and the application of such a control current for each RGB, wider IC operating temperature (-45 to 80 ℃), the internal DC-DC boost, as well as graphics acceleration instruction and some other features.
2013年4月22日星期一
Resistive touch screen oled module
This touch screen is controlled using a pressure sensing. A main part of the resistive touch screen resistive films screen is a very complex piece with the display surface, which is a multi-layered composite film as primary layer of glass or hard plastic plate, the surface coated with a layer of transparent metal oxide (transparent conductive resistance) of the conductive layer, above and then cover with a layer of outer surface hardening treatment, smooth plastic layer anti-rub, and its inner surface is also coated with a layer of coating, between them, have many of the small (less than 1/1000 inch) transparent the isolation point the two conductive layers separated by insulation. When the finger touches the screen, the two conductive layers on the touch point there will be a contact resistance change signal is generated on the X and Y directions, and then send the touch screen controller. The controller detects the contact and to calculate the position (X, Y), according to the operation of the simulated mouse. This is the basic principle of the resistive touch screen technology. Resistance class touch screen key material, commonly used transparent conductive coating material:
A, ITO, indium oxide, a weakly conductive body, characteristics when the thickness is reduced to 1800 angstroms (Å = 10-10 m) or less, will suddenly become transparent, the light transmittance was 80%, and then thin down light transmittance but The rise again decreased to a thickness of 300 angstroms to 80%. ITO is all resistive touch screen technology and capacitive touch screen technology are the main materials used, in fact, the resistive and capacitive touch screen technology Face ITO coating.lcd
Nickel gold coating, five-wire resistive touch screen of the outer conductive layer is good ductility nickel deposit coating materials, conductive outer layer due to frequent touch, use a good ductility nickel deposit materials in order to extend the life of , but the technology costs more expensive. Nickel deposit conductive layer scalability, but only for transparent conductors, not suitable as the face of the resistive touch screen, because of its high conductivity, and the metal is not easy to do very uniform thickness, suitable for voltage distribution layer, and only as a probe layer.lcd graphics
订阅:
博文评论 (Atom)
没有评论:
发表评论